Sony CPD-1730 Operating Instructions (primary manual) - Page 15

Power Saving Function This monitor is capable of reduced power consumption when used with a computer equipped with VESA Display Power Management Signaling (DPMS). By sensing the absence of the vertical sync singnal coming from the host computer, it will reduce power consumption as follows. State Horizontal sync signal Vertical sync signal Power Consumption Required resumption time Normal Operation Present Present 100% - Power Saving Present Not present Not present Not present approx. 20% approx. 3 sec. When Power Saving mode is activated, the O /3 indicator will be extinguished, leaving only the Power indicator lit. NOTE The Power Saving function will automatically put the monitor into the Power Saving state if the power switch is turned on without any video signal input. Once the vertical sync is sensed, the monitor will automatically return to its Normal operation state. This monitor is Energy Star compliant (Power Saving mode < 30W) when used with a US (115 V) or European (220 V) power supply. The Energy Star emblem does not represent EPA endorsement of any product or service. (EPA = U. S. Environmental Protection Agency) VESA is a trademark of the non-profit organization, Video Electronics Standard Association. Troubleshooting If you have a problem, check in the table below. Symptom No picture The picture is dark. The input signal from an equipment does not appear. Cause The power cord is disconnected. Countermeasure Connect the power cord. The power is turned off. Turn on the power. The adjusted condition is improper. Adjust D (brightness) (see page 8) or reset to factory-preset condition (see page 11). The equipment is disconnected. Connect the cable. You are using a video board other than IBM, Macintosh II or VESA standard. Use a video board that complies with signal timing and pin assignments on the CPD-1730. 15