Sony CSS-HD2 Operating Instructions - Page 15

 Notes  After attaching the camera to the Cyber-shot Station, the CHARGE lamp may blink slowly for 3 to 10 seconds. This indicates communication between the camera and the Cyber-shot Station, and it is not a malfunction.  If CHARGE lamp does not light or blinks for more than 10 seconds, refer to "Troubleshooting". Charging temperature The temperature range for charging is 0 °C to 40 °C (32 °F to 104 °F). However, to provide maximum battery efficiency, the recommended temperature range when charging is 10 °C to 30 °C (50 °F to 86 °F). On battery life  The battery life is limited. Battery capacity decreases little by little as you use it more and more, and as time passes. If the battery operating time seems shortened considerably, a probable cause is that the battery pack has reached the end of its life. Buy a new battery pack.  The battery life varies according to how it is stored and the operating conditions and environment in which each battery pack is used. Viewing images on a TV screen You can playback images by connecting the Cybershot Station to the TV with the A/V connecting cable (supplied) or the Component A/V Cable (supplied). Refer to the operating instructions supplied with the TV for connection. 1 Viewing images on a high-definition TV Connect the A/V OUT jack of the Cyber-shot Station and the Component AV jacks of the TV. Red White Audio Green Blue Red Y Pb/Cb Pr/Cr Component A/V Cable Viewing images on TVs other than highdefinition TV Connect the A/V OUT jack of the Cyber-shot Station and the audio/video input jacks of the TV. Red White Yellow Audio Video A/V connecting cable  Turn off the TV before connecting the Cybershot Station and TV with the Component A/V Cable.  The signal format to be output from the A/V OUT jack depends on the camera setting.  To view the 1080i format images, you need a TV compatible with 1080i format.  The audio to be output from the Cyber-shot Station via the A/V OUT jack is monaural.  The Cyber-shot Station is not compatible with the S-VIDEO connecting cable. 2 Turn on the power by pressing the (playback) button of the camera or the POWER button on the Remote Commander. Tips  The buttons on the camera or the Remote Commander may not function immediately after the camera is attached to the Cybershot Station. This occurs when the camera is booting up and is not a malfunction. Wait for about 10 seconds. 3 Turn on the TV and set the input switch to the input connected in step 1. 4 Press / on the Control buttons of the Remote Commander to select the image. You can also select the image by pressing / on the Control buttons of the camera.  The Cyber-shot Station is compatible with both NTSC and PAL TV systems. For further details, see the operating instructions supplied with the camera. 15-GB