Sony CX20 Operating Instructions - Page 11
Projecting
View all Sony CX20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
To connect to a video GBR/ Component output connector Left side Projecting Projecting the Picture ON/STANDBY indicator to video GBR/ component output Rear remote control detector White to audio output (L) Red to audio output (R) VCR A SMF-402 Signal Cable (not supplied) HD D-sub 15-pin (male) ↔ 3 × phono jack B A/V connecting adaptor (supplied) C Stereo audio connecting cable (not supplied) (Use a no-resistance cable.) Note Set the aspect ratio using "Wide Mode" on the Signal menu according to the input signal. 1 Plug the AC power cord into a wall outlet, then connect all equipment. The ON/STANDBY indicator lights in red and the projector goes into standby mode. 2 Press the ?/1 key. The ON/STANDBY indicator flashes in green and the Advanced Intelligent Auto-setup starts. The powered tilt adjuster rises and stops at the previously adjusted position and adjusts the focus. Projecting 11