Sony DCR-TRV22 Operating Instructions (primary manual) - Page 99
Adding an audio sound on the recorded tape, Audio dubbing, The A DUB CTRL screen appears.
View all Sony DCR-TRV22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Editing Audio dubbing Adding an audio sound on the recorded tape Choose a connection mentioned on page 97, and connect audio equipment or microphone to your camcorder. Then follow the procedure below. The POWER switch should be set to . Operate by touching the panel. (1) Insert the recorded tape into your camcorder. (2) Locate the recording start point. Press to start playing back. To pause playing back, press at the recording start point. You can fine adjust the recording start point by pressing / . (3) Press FN and select PAGE3. (4) Press A DUB CTRL. The A DUB CTRL screen appears. A DUB CTRL RET. REC PAUSE ARUEDCIO STDAURBT (5) Press AUDIO DUB. The green X indicator appears on the screen. (6) Press on your camcorder and at the same time start playing back the audio you want to record. The new sound is recorded in stereo 2 (ST2) during playback. While recording new sound, the red indicator appears on the screen. (7) Press on your camcorder at the point where you want to stop recording. You cannot perform audio dubbing: •On the tape recorded in the 16-bit mode •On the tape recorded in the LP mode •When the DV Interface is connected •On blank portions of a tape •When the write-protect tab of the cassette is set to lock To add new sound to previously recorded sections more precisely During playback, press ZERO SET MEMORY at the point where you want to stop recording new sound. Follow the procedure on page 75. Recording automatically stops at the point where ZERO SET MEMORY was pressed. We recommend that you add new sound on the tape recorded with your camcorder If you add new sound on the tape recorded with another camcorder (including other DCR-TRV19/TRV22/TRV33), the sound quality may become deteriorated. 99