Sony HCD-GS100 Operating Instructions - Page 15

Tuner Setting presets through manual tuning 1 Press TUNER/BAND repeatedly to select "FM" or "AM". 2 Press TUNING - or + repeatedly to tune in the desired station. 3 Press MENU. 4 Press PRESET - or + repeatedly until "MEMORY" appears, then press ENTER. A preset number appears. 5 Press PRESET - or + repeatedly to select the desired preset number. 6 Press ENTER. 7 Repeat steps 1 to 6 to store other stations. Other Operations To Do this Tune in a station Follow the procedure described in with a weak "Setting presets through manual signal tuning". Stop setting presets Press MENU. Change the preset station Start over from step 1. To change the AM tuning interval The AM tuning interval is factory-set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the system. While holding down ENTER, turn the system back on. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure. Note You cannot change the AM tuning interval in Power Saving Mode. Tips • The preset stations are retained for about a day even if you disconnect the mains lead or if a power failure occurs. • You can label the preset stations (see page 16). • To improve broadcast reception, reorient or move the supplied antennas near a window or outdoors. 15US