Sony KDL 46S4100 Operating Instructions - Page 20
mount holes located on the rear of the TV., Use the hardware listed below not supplied. - stand
UPC - 027242738133
View all Sony KDL 46S4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Getting Started 2 Secure the TV to the Stand. Use the optional hardware listed below (not supplied): • M6 × 12-18mm anchor bolt (screwed into the TV's Table-Top Stand). • A screw or similar (attach it to the TV stand). • Rope or chain (strong enough to support the weight of the TV). Make sure that there is no excess slack in the rope or chain. An alternative way to secure the TV is with an optional Sony Support Belt Kit. Anchor bolt Screw hole on the Table-Top Stand Screw Contact Sony Customer Support to obtain the optional Support Belt Kit by providing your TV model name. - For United States call: 1-800-488-7669 or visit: www.sony.com/accessories - For Canada call: 1-877-899-7669 3 Anchor the TV to the Wall. Use the hardware listed below (not supplied). • Two M6 × 12-18mm anchor bolts (screw into the top-most wall- mount holes located on the rear of the TV). • Rope or chain (attach to one M6 anchor bolt). • Wall-anchor (attach to the wall stud) strong enough to support the weight of the TV (pass the rope through the wall-anchor, then attach to the other M6 anchor bolt). Anchor bolts Wall-mount holes Rope or chain Wall-anchor Measure 2 provides minimal protection against the TV toppling over. For further protection, follow all three measures recommended above. If an electric screwdriver is used, set the torque to tighten at approximately 2.0 N·m {20 kgf·cm}. 20