Sony KLV-S32A10 Operating Instructions - Page 19
Satellite Receiver and Cable/Antenna, AUDIO and S VIDEO output jacks to the TV's AUDIO and S VIDEO - tuner
View all Sony KLV-S32A10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Connecting the TV Connecting the TV Satellite Receiver and Cable/Antenna z If you connect the Digital Satellite Receiver with component video cables, see page 20. This scenario shows a SAT Box connected through the video inputs and the Cable/Antenna connected through the VHF/UHF input. Satellite signals are selected by the SAT Box through the video inputs while TV signal is selected by the TV tuner. To connect a satellite receiver 1 Connect the satellite antenna cable to the satellite receiver's satellite input jack. 2 Use an A/V and S VIDEO cables to connect the satellite receiver's AUDIO and S VIDEO output jacks to the TV's AUDIO and S VIDEO input jacks (VIDEO 1 or 3). 3 Connect the supplied 75-ohm coaxial cable from the antenna to the TV's VHF/UHF input jack. 4 Run the Initial Setup program, as described in "Setting Up the Channel List" on page 30. If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. Satellite Receiver Satellite antenna cable 75-ohm coaxial cable S VIDEO cable S VIDEO Rear of TV Y VHF/UHF PC AUDIO IN Notes on Using This Connection VIDEO (yellow) AUDIO-L A/V cable (white) AUDIO-R (red) S VIDEO PB VIDEO PR L (MONO) L L AUDIO AUDIO R R R 1 3 4 VIDEO IN HD/DVD IN (1080i/720p/480p/480i) AUDIO OUT To Do This ... Watch the satellite receiver Set up the remote control to operate the satellite receiver Activate the remote control to operate the satellite receiver Control satellite receiver functions with the remote control Label video inputs to easily identify equipment connected to the TV Do This ... Press WEGA GATE to select the Satellite input (Video 1, 2 or 3) in the External Inputs list. or Press TV/VIDEO repeatedly to select the satellite receiver input (Video 1, 2 or 3). You must program the remote control. See "Programming the Remote Control" on page 34. Press SAT/CABLE (FUNCTION). See "Operating a Satellite Receiver" on page 36. See the instructions for setting up Label Video Inputs on page 61. 19