Sony LBT-W900AV Operating Instructions - Page 11
Saving power in, standby mode For, LBT-W900AV, XB800AV only
View all Sony LBT-W900AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
To erase a preset number 1 Press and hold TUNER MEMORY until the preset number flashes in the display. 2 Press TUNING +/- to select the preset number you want to erase. Select "ALL ERASE" to erase all preset numbers. 3 Press ENTER/NEXT. When you erase a preset number, all the following preset numbers shift up and reduce by one. To change the AM tuning interval (Except for the European and the Middle Eastern models) The AM tuning interval is factory-preset to 9 kHz (10 kHz in some areas). To change the AM tuning interval to 10 kHz (or 9 kHz), press TUNER/BAND repeatedly until "AM" appears, then turn off the system. While holding down ENTER, turn the system back on. When you change the interval, the AM preset stations will be erased. To reset the interval, repeat the same procedure. Note The preset stations are canceled when you disconnect the power cord or if a power failure occurs for more than half a day. Saving power in standby mode (For LBT-W900AV/ XB800AV only) In standby mode, you can reduce the power consumption to a minimum (Power Saving mode) and thus save energy. 1/u (Power) POWER SAVE/DEMO (STANDBY) DISPLAY / Press POWER SAVE/DEMO (STANDBY) while the system is turned off. The system switches to the Power Saving mode and the clock display disappears. The system is turned on/off by pressing 1/u. To cancel the Power Saving mode Press DISPLAY. The clock display reappears. continued 11