Sony MHC-GX90D Operating Instructions (primary manual) - Page 68

Messages, Optional components

Get Sony MHC-GX90D - Dvd Shelf System PDF manuals and user guides View all Sony MHC-GX90D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 68 highlights

Problems and remedies (continued) Optional components There is no sound. • Refer to General item "There is no sound." on page 64 and check the condition of the system. • Connect the component properly (see page 61) while checking: - if the cords are connected properly. - if the cord plugs are firmly inserted all the way. • Turn on the connected component. • Refer to the operating instructions included with the connected component and start playing. If other troubles not described above occur, reset the system as follows: 1 Unplug the power cord. 2 Plug the power cord back in. 3 Press x, ENTER, and ?/1 at the same time. 4 Press ?/1 to turn on the system. The system is reset to the factory settings except for DVD settings. All the settings other than DVD settings you made are cleared. Messages One of the following messages may appear or flash in the display during operation. NO DISC • There is no disc in the disc tray. "PROTECT" and "PUSH POWER" appear alternately. • A strong signal was input. Press ?/1 to turn off the system, leave the system turned off for a while, then press ?/1 again to turn on the system. If "PROTECT" and "PUSH POWER" appear alternately even after the system is turned on again, press ?/1 to turn off the system and check the speaker cord. PUSH STOP • You pressed PLAY MODE during play. READING • The system is reading the TOC information of the disc. Some buttons are not available. WAIT • The function is switching to the tuner. The disc tray does not open and "LOCKED" appears. • Contact your Sony dealer or local authorized Sony service facility. 68GB

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
68
GB
Messages
One of the following messages may appear or
flash in the display during operation.
NO DISC
•
There is no disc in the disc tray.
“PROTECT” and “PUSH POWER” appear
alternately.
•
A strong signal was input. Press
?/1
to turn off
the system, leave the system turned off for a
while, then press
?/1
again to turn on the
system. If “PROTECT” and “PUSH POWER”
appear alternately even after the system is turned
on again, press
?/1
to turn off the system and
check the speaker cord.
PUSH STOP
•
You pressed PLAY MODE during play.
READING
•
The system is reading the TOC information of
the disc. Some buttons are not available.
WAIT
•
The function is switching to the tuner.
The disc tray does not open and “LOCKED”
appears.
•
Contact your Sony dealer or local authorized
Sony service facility.
Optional components
There is no sound.
•
Refer to General item “There is no sound.” on
page 64 and check the condition of the system.
•
Connect the component properly (see page 61)
while checking:
—
if the cords are connected properly.
—
if the cord plugs are firmly inserted all the
way.
•
Turn on the connected component.
•
Refer to the operating instructions included with
the connected component and start playing.
If other troubles not described above
occur, reset the system as follows:
1
Unplug the power cord.
2
Plug the power cord back in.
3
Press
x
, ENTER, and
?/1
at the same
time.
4
Press
?/1
to turn on the system.
The system is reset to the factory settings
except for DVD settings. All the settings other
than DVD settings you made are cleared.
Problems and remedies (continued)