Sony RDH-GTK37iP Operating Instructions - Page 27

• You may not be able to operate the iPod/ iPhone using buttons on the remote control or unit due to the operation of the system and iPod/iPhone are different. In this case, use the control buttons on the iPod/iPhone. The iPod/iPhone cannot be charged. • If the battery of the iPod/iPhone is empty, the system may not be able to charge it even if you connect it to the system. In this case, recharge it with a computer, etc. then connect it to the system. • Make sure the iPod/iPhone is connected securely. • Make sure the system is turned on when you connect an iPod/iPhone to the system. The ring volume of the iPhone does not change. • Adjust the ring volume on the iPhone. USB device There is no sound. • The USB device is not connected correctly. Turn off the system and reconnect the USB device. There is noise, skipping, or distorted sound. • You are using an unsupported USB device. Check the information on the websites about compatible USB devices (page 25). • Turn off the system and reconnect the USB device. • The music data itself contains noise, or the sound is distorted. Noise may have been entered when creating music data due to the conditions of the computer. Create the music data again. • The bit rate used when encoding audio files was low. Send audio files with higher bit rate to the USB device. "READING" is displayed for an extended time, or it takes a long time before playback starts. • The reading process can take a long time in the following cases. - There are many folders or files on the USB device. - The file structure is extremely complex. - The memory capacity is excessive. - The internal memory is fragmented. "OVER CURRENT" appears. • A problem has been detected with the level of electrical current from the port. Turn off the system and remove the USB device from the port. Make sure there is no problem with the USB device. If this display pattern persists, contact your nearest Sony dealer. Erroneous display. • The data stored in the USB device may have been corrupted, send the music data to the USB device again. • The character codes that can be displayed by this system are numbers and alphabets only. Other characters that cannot be displayed appear as "_". The USB device is not recognized. • Turn off the system and reconnect the USB device, then turn on the system. • Check the information on the websites about compatible USB devices (page 25). • The USB device does not work properly. Refer to the operating instructions of your USB device on how to deal with this problem. Playback does not start. • Turn off the system and reconnect the USB device, then turn on the system. • Check the information on the websites about compatible USB devices (page 25). Additional Information 27GB