Sony RDR-HX730 Operating Instructions - Page 96
Dubbing, Display, Remote control, panel display when the recorder is turned
View all Sony RDR-HX730 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
The recorder automatically starts recording when the satellite receiver is turned on. , The Synchro-Rec function was activated. Turn off the satellite receiver and cancel the Synchro-Rec function (page 50). Dubbing You dubbed a title, but the title did not appear in the HDD Title List. , The title contained a copy protection signal, so it was moved (page 72). High-speed dubbing is not possible. , The title cannot be dubbed at high-speed (page 71). Even if A-B erasure is performed so that a title does not contain mixed picture sizes, it is still treated as a title with mixed picture sizes. Display The clock has stopped. , Set the clock again (page 81). , The clock stopped due to a power failure that lasted for more than 1 hour. Reset the clock (page 81). The TIMER REC indicator is flashing. , The disc does not have enough space. , Insert a recordable disc inside the recorder. , The inserted DVD is protected (page 37). The recording mode indication is incorrect. , When the recording or dubbing is less than ten minutes, or if a picture with little movement is displayed for more than ten minutes, the recording mode indication may be displayed incorrectly. Note that the actual recording or dubbing itself was correctly made in the selected recording mode. , After playing titles recorded in EP and SLP mode, the recording mode indication may change depending on the recorded program. The clock does not appear in the front panel display when the recorder is turned off. , "Power Save Standby" in the "Others" setup is set to "On" (page 90), and the recorder is in standby mode. Remote control The remote does not function. , Batteries are weak. , The remote is too far from the recorder. , The remote's manufacturer code returned to the default setting when you replaced the batteries. Reset the code (page 20). , The remote is not pointed at the remote sensor on the recorder. , Different command modes are set for the recorder and remote. Set the same command mode (page 21). The default command mode setting for this recorder and the supplied remote is DVD3. , Press x STOP on the unit while the recorder is turned off to check the current command mode. 96