Sony STR-DE897/S Operating Instructions - Page 52

To activate the input after programming Press the programmed button to activate the input you want. To cancel learning Press RM SET UP during any step. The remote automatically exits the learning mode. To clear the learned codes Start over from step 1. After step 3, press TV ?/1 for more than 2 seconds. The indicator lights up twice slowly and the learned code is cleared. If TV ?/1 is pressed less than 2 seconds, the learning procedure returns to the beginning of step 5. When a learned code is cleared, if the button was previously programmed for another input selector, the programmed code for that button can be used. To clear the memory of the remote To clear all programmed and learned signals, do the following to reset the remote to factory settings. Press ?/1, AV ?/1 and MASTER VOL - at the same time. The indicator flashes 3 times, then goes off. To use a command that has been learned When selecting a learned input, press the learned button for that input. Performing several commands in sequence automatically (Macro Play) The Macro Play function lets you link several IR codes in a sequential order as a single command. The remote provides 2 macro lists (M1 and M2). You can specify up to 10 IR codes for each macro list. Setting the sequence of IR codes 1 Press M1 (or M2) while holding down RM SET UP. The indicator lights up. 2 Press the numeric buttons to select the macro step number. For example, to program step 1, press 1. The indicator flashes slowly. 3 Point the remote control code receiver section of the remote towards the receiver/transmitter on the remote control to be learned. 4 Press the appropriate button on the remote control to be learned to send the remote button code. Lightly pressing the button once should be sufficient. If learning is completed successfully, the indicator slowly flashes twice and the remote automatically exits the learning mode. When learning is not completed successfully, the indicator flashes 4 times in quick succession and the procedure returns to step 4. 5 Repeat steps 1 through 4 to program up to 10 IR codes. 52GB