Sony STR-K850P Operating Instructions - Page 44
Troubleshooting continued - protect
View all Sony STR-K850P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Troubleshooting (continued) There is no sound or only a very low-level sound no matter which component is selected. • Check that the speakers and components are connected securely and correctly. • Check that both the receiver and all the components are turned on. • Check that the MASTER VOLUME control is not set at "VOL MIN". • Check that the SPEAKERS (OFF/A/B/A+B) button is not set to off and is set accordingly to your SPEAKERS FRONT system (page 23). • Press MUTING on the remote to cancel the muting function. • Check that the headphones are not connected. • The protective device on the receiver has been activated because of a short circuit ("PROTECT" flashes). Turn off the receiver, eliminate the short-circuit problem and turn on the power again. There is no sound from a specific component. • Check that the component is connected correctly to the audio input jacks for that component. • Check that the cord(s) used for the connection is (are) fully inserted into the jacks on both the receiver and the component. • Check that you have selected the correct component on the receiver. There is no sound from one of the front speakers. Connect a pair of headphones to the PHONES jack to verify that sound is output from the headphones (page 23). If only one channel is output from the headphones, the component may not be connected to the receiver correctly. Check that all the cords are fully inserted into the jacks on both the receiver and the component. If both channels are output from the headphones, the front speaker may not be connected to the receiver correctly. Check the connection of the front speaker which is not outputting any sound. The left and right sounds are unbalanced or reversed. • Check that the speakers and components are connected correctly and securely. • Adjust balance parameters in the LEVEL menu. There is severe hum or noise. • Check that the speakers and components are connected securely. • Check that the connecting cords are away from a transformer or motor, and at least 3 meters away from a TV set or fluorescent light. • Move your TV away from the audio components. • The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with alcohol. There is no sound or only a very low-level sound is heard from the center or / and surround speaker. • Make sure the sound field function is on (press MOVIE or MUSIC). • Select a sound field containing the word "C.ST.EX" (pages 25). • Adjust the speaker level (page 20). • Make sure the center or/and surround speaker size parameter is set to either "SMALL" or "LARGE" (page 19). There is no sound from the active sub woofer. • Check that the sub woofer is connected correctly and securely. • There is no sound output from the SUB WOOFER terminal depending on the sound field (page 50). The surround effect cannot be obtained. Make sure the sound field function is on (press MOVIE or MUSIC). Dolby Digital or DTS multi channel sound is not reproduced. • Check that the playing DVD, etc. is recorded in Dolby Digital or DTS format. • When connecting the DVD player, etc. to the digital input jacks of this receiver, check the audio setting (settings for the audio output) of the connected component. 44US