Sony STR-K850P Operating Instructions - Page 45

Additional Information Recording cannot be done. • Check that the components are connected correctly. • Select the source component with input selector button. • Make sure that INPUT MODE is set to "ANALOG" (page 22) before recording from a digital component connected to the analog MD/TAPE terminal. • Make sure that INPUT MODE is set to "COAX IN" or "OPT IN" (page 22) before recording from a digital component connected to the DIGITAL MD/TAPE OUT terminals. The FM reception is poor. Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe. Outdoor FM antenna Receiver ANTENNA AM y FM 75Ω COAXIAL Ground wire (not supplied) To ground Radio stations cannot be tuned in. • Check that the antennas are connected securely. Adjust the antennas and connect an external antenna if necessary. • The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning. • Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning). • No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 31). • Press DISPLAY so that the frequency appears in the display. There is no picture or an unclear picture appears on the TV screen or monitor. • Select the appropriate input selector on the receiver. • Set your TV to the appropriate input mode. • Move your TV away from the audio components. The remote does not function. • The VIDEO3, TV/SAT, PHONO, AUX, SOURCE, DIRECT, AAC BI-LING, SB DECODING, 12 and ON SCREEN buttons on the remote are not available. • Point the remote at the remote sensor g on the receiver. • Check that the command mode of the remote corresponds to that of the receiver. If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver (pages 35 and 39). • Press MAIN MENU on the remote before you use the V/v/B/b buttons for receiver operation. • To activate the buttons with orange printing, press ALT first before pressing the buttons. • Remove any obstacles in the path between the remote and the receiver. • Replace both batteries in the remote with new ones, if they are weak. • Make sure you select the correct input selector on the remote. • If the remote is set to operate the TV only, use the remote to select a source or component other than TV before operating the receiver or other component. If you are unable to remedy the problem using the troubleshooting guide Clearing the receiver's memory may remedy the problem (page 16). However, note that all memorized settings will be reset to their factory settings and you will have to readjust all settings on the receiver. If the problem persist Consult your nearest Sony dealer. Clearing the receiver's memory To clear See All memorized settings page 16 Customized sound fields page 29 45US