TEAC AP-505 Owners Manual EN FR SP - Page 8

Rear panel names and functions A F BC D E A Analog audio input (INPUTS) connectors Use these to input stereo analog audio. Connect these connectors to the audio output connectors of a preamplifier or another device such as a DAC that has a preamplifier function. oo This unit's XLR connectors are 2: HOT. Use commercially-available audio cables for connections. RCA: RCA cables XLR: XLR cables Using with STEREO output mode Connect this unit's R input connector to the R output connector of the audio output device, and this unit's L input connector to the L output connector of the other device (page 10). Using with BI-AMP or BTL output mode Connect this unit's L connector to the L or R connector of the audio output device. The R connector of this device is not used (pages 11 and 12). B INPUT SELECTOR switch Use this to switch between input sources. VVDo not switch this when the unit is on. Failure to do so could result in sudden loud noises that could damage speakers and harm your hearing. C OUTPUT MODE switch This sets the output mode. STEREO: stereo power amplifier (page 10) BI-AMP: mono bi-amplifier (page 11) BTL: mono power amplifier (page 12) VVAlways disconnect speakers before changing the output mode. Reconnect the speakers after changing the mode. D SPEAKERS terminals This unit supports speakers that have a nominal impedance of 4 Ω - 16 Ω when the output mode is STEREO or BI-AMP and 8 Ω - 16 Ω when BTL. Use commercially-available speaker cables to connect the speakers. E Power inlet (~IN) Connect the supplied power cord here. After all other connections are complete, connect the power cord's plug to a wall outlet. VVDo not use any power cord other than the one included with this unit. Use of other power cords could result in fire or electric shock. VVUnplug the cord from the outlet when not using the unit for a long time. F Maintenance port This is used for maintenance. Do not connect anything to this port unless instructed to do so by our service department. 8