TEAC CD-W540E User Manual - Page 13
Rear Panel
View all TEAC CD-W540E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Rear Panel Figure 3 illustrates the rear panel of the CD-RW Drive. Rear Panel S1 analog audio CSEL/Slave/Master interface connector configuration jumper connector power frame connector ground Figure 3. Rear Panel of the CD-RW Drive S1: Reserved for factory use only. analog audio output connector: You can use an audio cable to connect this connector to the audio input connector on a sound card. Pin assignments are described in the following table: Pin Number 1 2 3 4 Audio Signal Left signal Ground Ground Right signal CSEL/Slave/Master configuration jumper: The CD-RW drive includes three pairs of jumper pins on the rear panel that allow you to set the drive to CSEL, Slave, or Master mode. (For more information, see"Configuring the CD-RW Drive" and Figure 5 on page 7.) interface connector: Use the included IDE interface ribbon cable to connect the CD-RW drive to an IDE interface in your computer. (For more information, see "Installing the CD-RW Drive" on page 8 and Figure 7 on page 9.) power connector: Connect the power connector to the +5VDC and +12VDC power sources. The +5VDC terminal is on the left as you face the rear panel; the +12VDC terminal is on the right. The two center terminals are ground terminals. (For more information, see "Installing the CD-RW Drive" on page 8 and Figure 7 on page 9). FG: Frame ground. This is a ground connection for the CD-RW drive. TEAC CD-RW Drive User's Manual 5