TEAC DM-3200 DM-3200 Automation Manual - Page 21

4 - Operation : Writing Mix Moves Write To End: When the Write Revert Time is set to ∞s, you are essentially telling the automation system to maintain a control's last setting from the point where the automation recording ends, all the way to the end of the program. This is called Write To End. In this case, any mix moves existing in the time between the end of automation recording and the end of the program will be erased. NOTE A Write/Trim to End operation must be completed by stopping the timecode. Manually disabling Write or Trim mode while timecode is running will not perform a Write To End operation. AUTO REVERT must be enabled to use Write To End. See the diagrams below to understand how this works: Existing Static Fader Position 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -9 -12 Fader Movement Touch Fader Release Fader Stop Time Code Figure 4.9: Write to End over previous Static fader position Existing Fader Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -9 -12 Fader Movement Touch Fader Release Fader Stop Time Code Figure 4.10: Write to End over previous Dynamic fader moves TASCAM DM-3200 Automation Guide 21