TEAC DM-3200 DM-3200 Automation Manual - Page 30

4 - Operation : Trimming Mix Moves Trim To End When the Trim Revert Time is set to ∞s, you are essentially telling the automation system to maintain the offset created by the trim operation from the point where trimming ends, all the way to the end of the program. NOTE A Write/Trim To End operation must be completed by stopping the timecode. Manually disabling Write or Trim mode while timecode is running will not perform a Write To End operation. See the diagrams below to understand how this works: Existing Fader Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -9 -12 Raise Fader & Release Stop Time Code Figure 4.20: Trimming fader moves with Trim to End enabled Existing POD Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -12 Mix Move 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec +12 +6 +3 0 -3 -6 -9 -12 Move POD & Release Stop Time Code Figure 4.21: Trimming POD and encoder moves with Trim to End enabled 30 TASCAM DM-3200 Automation Guide