TEAC P-55-111 Instruction Manual - Page 41

of longer and shorter lines is aligned or which pair

Get TEAC P-55-111 PDF manuals and user guides View all TEAC P-55-111 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

SECTION 14 : Getting Label Print Job Started 8) After the second pattern has been printed, take out the medium. NOTE - The upper and lower test patterns relative to the center hole are the same, and so are the left and right test patterns. - The upper and lower scales relate to vertical adjustment and the left and right scales relate to horizontal adjustment. 9) Pairs of longer and shorter lines are printed along the vertical and horizontal scales. Determine which pair of longer and shorter lines is aligned (or which pair of lines has the slightest displacement between), enter the corresponding values in the Horizontal and Vertical boxes on the Maintenance tab, and click OK. (In our example, you need to enter 8 in the Vertical box.) 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
SECTION 14 : Getting Label Print Job Started
41
8
) After the second pattern has been printed, take out
the medium
.
NOTE
- The upper and lower test patterns relative to the center hole are the same, and so are the left
and right test patterns.
- The upper and lower scales relate to vertical adjustment and the left and right scales relate to
horizontal adjustment.
9)
Pairs of longer and shorter lines are printed along the
vertical and horizontal scales. Determine which pair
of longer and shorter lines is aligned (or which pair of
lines has the slightest displacement between), enter
the corresponding values in the Horizontal and
Vertical boxes on the Maintenance tab, and click
OK
.
(In our example, you need to enter 8 in the Vertical
box.)