TP-Link T1500G-10MPS T1500G-10MPSUN V1 Installation Guide - Page 9

Smart PoE+ Switch When the PoE LED is on, the port LED is indicating the power supply status. LED PWR SYS FAN PoE MAX Speed or PoE SFP1, SFP2 Status On Off Flashing Flashing On/Off Green Yellow On Flashing Off Green On Flashing Indication The switch is powered on The switch is powered off or power supply is abnormal Power supply is abnormal The switch works properly The switch works improperly All the fans work properly Not all the fans work properly The remaining PoE power≤7W The remaining PoE power keeps ≤7W after this LED is on for 2 minutes The remaining PoE power>7W The port is supplying power normally The supply power exceeds the corresponding port's maximum power Yellow Off Green Yellow Off On Flashing On Flashing On Flashing Overload or short circuit is detected Power-on self-test has failed No PoE power supply is provided on the port A 1000Mbps device is connected to the corresponding port, but no activity Data is being transmitted or received A 10/100Mbps device is connected to the corresponding port, but no activity Data is being transmitted or received No device is connected to the corresponding port Reset With the switch powered on, press Reset button for 5 seconds to reset the software setting to its factory default settings. 10/100/1000Mbps RJ45 Port and PoE Port Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding Speed or PoE LED. SFP Port Designed to install the SFP module. T1500G-10MPS features 2 SFP transceiver ports. Introduction 03