Thermador HMCN42FS User Manual - Page 6

OPERATION IMPORTANT: The most effective method of removing vapors produced during cooking is to: ❑ Switch the ventilator ON prior to cooking or as soon as you begin cooking. ❑ Switch the ventilator OFF a few minutes after you have finished cooking. Display for fan setting Fan follow-on Light Fan OFF Reduce fan Fan ON and speed increase speed Acoustic signal: ❑ When a button is pressed, this is verified by an acoustic signal. Switching off the acoustic signal: ❑ Simultaneously press buttons 0 and + until a signal is emitted after approx. 3 seconds. Switching the fan OFF: ❑ Press the 0 button. The displayed { goes out shortly afterwards. Or: ❑ Keep pressing the - button until the fan switches off. The displayed { goes out shortly afterwards. Intensive setting: Maximum power is obtained at the intensive setting. It is only required for short intervals. ❑ Keep pressing the + button until a ç appears in the display. ❑ If the intensive setting is not cancelled by hand, the fan will automatically switch back to step } after 10 minutes. Fan follow-on: ❑ Press the ! button or push in the filter drawer. The fan runs for 10 minutes at setting 1. At the same time a dot flashes in the display. Then the fan switches off automatically. Switching on the acoustic signal: ❑ Repeat the process. Switching the fan ON ❑ Press the + button or pull out the filter drawer. Setting the required fan speed: ❑ Press the + button. The fan speed is increased by one step. ❑ Press the - button. The fan speed is reduced by one step. Lighting: ❑ Briefly press the a button to switch the light on and off. ❑ The light can be switched on at any time, even though the fan is switched off. ❑ Adjusting the brightness: Hold down the a button until the desired brightness is obtained. 6