Toro 20333 Operation Manual - Page 18
Cleaning the Mower - engine
UPC - 021038203331
View all Toro 20333 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
6. Remove the blade brake clutch shield (Figure 31). 7. Brush or blow out debris from the inside of the shield and around all the parts. 8. Install the blade brake clutch shield that you previously removed. 9. Install the blade driver and disk that you previously removed. 10. Install the blade and the stiffener that you previously removed (Figure 31). 11. Install the blade nuts and torque them to 15 to 27 ft-lb (20 to 37 N-m). Cleaning the Mower Service Interval: Before each use or daily 5. Turn the water on. 6. Start the engine and run it until there are no more clippings that come out from under the mower housing. 7. Stop the engine. 8. Shut off the water and disconnect the garden hose from the mower. 9. Start the engine and run it for a few minutes to dry the housing to prevent it from rusting. 10. Allow the engine to cool before storing the mower in an enclosed area. WARNING The mower may dislodge material from under the mower housing. • Wear eye protection. • Stay in the operating position (behind the handle) when the engine is running. • Do not allow bystanders in the area. For best results, clean the mower soon after you have completed mowing. 1. Lower the mower to its lowest cutting height setting. Refer to Adjusting the Cutting Height. 2. Move the mower onto a flat paved surface. 3. Wash out the area under the rear deflector where the clippings go from the housing to the grass bag. Note: Wash out the area with the bag-on-demand in both the fully forward and fully rearward positions. 4. Attach a garden hose that is connected to a water supply to the washout port on the mower housing (Figure 32). 1. Washout port Figure 32 18