Toro 20333 Operation Manual - Page 5

Setup Important: Remove and discard the protective plastic sheet that covers the engine. 1 Installing the Blade Control Bar No Parts Required Procedure Install the blade control bar into the upper handle (Figure 3). 1. Remove the handle knobs from the mower housing (Figure 4). Important: Route the cables to the outside of the handle knobs as you install the handle. Figure 3 Figure 4 2. Move the handle to the operating position. 3. Install and tighten the handle knobs that you removed in step 1 (Figure 4). 2 Installing the Handle No Parts Required Procedure WARNING Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cables when folding or unfolding the handle. • If a cable is damaged, contact an Authorized Service Dealer. 5