Toshiba 36HF71 Owners Manual - Page 19
Adding Channels to the TV's Memory, Programming Now
View all Toshiba 36HF71 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Introduction Connecting your TV Using the Remote Control Adding channels to the TV's memory When you press Channel y or z, your TV will stop only on the channels stored in the TV's channel memory. Follow the steps below and on the next page to program all active channels into the TV's memory. Programming channels automatically Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are stored automatically, you can manually add or erase individual channels. To program channels automatically: 1. Press MENU, and then press x or • until the SET UP menu appears. 2. Press y or z until the TV/CABLE is highlighted. 3. Press x or • to highlight either TV or CABLE, depending on which you use. If you use an antenna, highlight TV; if you use cable, highlight CABLE. SET UP LANGUAGE CLOCK SET ANT 1 / 2 TV / CABLE CH PROGRAM ADD / ERASE T I LT CORRECT I ON ENGL I SH 00:00 ANT1 TV / CABLE ADD 0 4. Press z to select CH PROGRAM. SET UP LANGUAGE CLOCK SET ANT 1 / 2 TV / CABLE CH PROGRAM ADD / ERASE T I LT CORRECT I ON ENGL I SH 00:00 ANT1 CABLE ADD 0 Note: To tune the TV to a channel not programmed in the channel memory, you must use the Channel Number buttons on the remote control. LIGHT RECALL POWER TV CABLE VCR MUTE TV/VIDEO TIMER 123 CH 456 789 CH RTN VOL 100 0 ENT FAVORITE ADV/ PIP CH PIC SIZE FAV MENU/ ENTER FAV STPOBE ADV/ EXIT PIP CH STOP SOURCE PLAY PIP REC TV/VCR REW FF STILL LOCATE SWAP Channel yz MENU yzx • Setting up your TV Using the TV's Features Appendix 5. Press x or • to start channel programming. The TV will automatically cycle through all the TV or Cable channels (depending on which you selected), and store all active channels in the channel memory. While the TV is cycling through the channels, the message "Programming Now-Please Wait" appears. 6. When channel programming is complete,the message "Completed" appears. 7. Press Channel y or z to view the programmed channels. Adding and erasing channels manually After you have programmed the channels automatically, you can manually add or erase specific channels. To add or erase channels: 1. Select the channel you want to add or erase. If you are adding a channel, you must select the channel using the Channel Number buttons. 2. Press MENU, and then press x or • until the SET UP menu appears. (continued on next page) 19 Index