Toshiba W-804 Owners Manual - Page 10
Preparation, How to Use the Remote Control
View all Toshiba W-804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
PREPARATION How to Use the Remote Control This section explains how to get ready for remote control operation. Whenever you operate the VCR, press VCR to set the remote control operating the VCR. Setting up the Remote Control 1 Open the battery compartment on the front of the Remote Control by pressing on the centre of the slide cover and pull off in one motion in the direction of the arrow. 1 2 2 Install 2 batteries ("AAA" size) following the polarity diagrams. 3 Close the battery compartment lid. 4 Point the remote control at the VCR and press the buttons within the operating range. Distance: within about 7 m from the front of the remote sensor Angles: within about 30˚ in every direction Notes on batteries • The life of the batteries is about 1 year depending on the conditions of use. • If the remote control does not operate correctly, replace all batteries with new ones. • If the remote control is not to be used for a long period of time, remove the batteries to avoid possible damage from battery corrosion. Caring for the remote control • Do not expose the remote sensor of the VCR to a strong light source such as direct sunlight or illumination (especially high-frequency lighting) when using the remote control. • Be careful not to spill water on the remote control or to place it on anything wet, and avoid sharp impacts. 10