Toshiba W-804 Owners Manual - Page 41
DSS Satellite Receiver Set Up
View all Toshiba W-804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
RECORDING DSS® Satellite Receiver Set-up The VCR can directly control channel selecting of the connected DSS® satellite receiver. RECORDING DSS® Satellite Receiver Control This VCR needs to be connected to a DSS® satellite receiver equipped with an infrared wireless remote control. You can select satellite channels from the DSS® satellite receiver by operating this VCR. DSS® is registered trademark of DIRECTV, Inc., a unit of GM Hughes Electronics. It is also possible to automatically change the satellite channels according to your program setting in the timer program recording. Placing the DSS® Satellite Receiver Put the DSS® satellite receiver on the top of the VCR as shown below. Do not block the sensor window. DSS® satellite receiver Sensor window Wall Front of the VCR Connection Type Type A Satellite antenna RF IN 3CH RF OUT 4CH DSS® satellite receiver RF IN RF OUT Type B Satellite antenna Incoming cable DSS® satellite receiver 3CH 4CH LINE IN 1 The infrared signals come out of the sensor window and the front of the VCR. Then they bounce off walls and other objects in the room and are received by the DSS® satellite receiver. The VCR sends out infrared signals to your DSS® satellite receiver even during timer program recording. Notes • If the channels cannot be controlled properly because the infrared signal fails to reach the DSS® satellite receiver, change the position of the receiver on the VCR so that it can receive the signal. • Keep the DSS® satellite receiver turned on even while the VCR is in the timer program recording. LINE OUT (Continued) 41