Home > Toshiba Manuals > VCRs > Toshiba W528 > Manual Viewer

Toshiba W528 Owners Manual

Toshiba W528 Manual

Toshiba W528 manual table of contents:

  • Toshiba W528 | Owners Manual - Page 1
    SQPB Video Cassette Recorder W-528 W-522 W-422 OWNER'S MANUAL
  • Toshiba W528 | Owners Manual - Page 2
    ... interference that may cause undesired operation. Contact: Toshiba America Consumer Products, Inc. Address: 1420 Toshiba Drive, Lebanon, TN 37087 Telephone: 615-449-2360 User ...: Changes or modification made to this equipment not expressly approved by Toshiba Corporation or parties authorized ...
  • Toshiba W528 | Owners Manual - Page 3
    ... video cassette recorder (VCR) is compatible with any other VCR bearing the mark. HQ VHS equipment is also compatible with existing, non-HQ VHS equipment. INTRODUCTION As an ENERGY STAR® Partner, TOSHIBA has determined that this product or product model meets the ENERGY STAR®...
  • Toshiba W528 | Owners Manual - Page 4
    ... CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS GIVEN IN THIS OWNER'S MANUAL AND THOSE MARKED ON THE UNIT. RETAIN THIS .... 1. Read owner's manual After unpacking this product, read the owner's manual carefully, and follow all the operating and other instructions. 2. Power Sources This ...
  • Toshiba W528 | Owners Manual - Page 5
    ... information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge ... UNIT (NEC SECTION 810-20) ELECTRIC SERVICE EQUIPMENT GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART ...
  • Toshiba W528 | Owners Manual - Page 6
    ...sold with the product. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the ... d) If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating ...
  • Toshiba W528 | Owners Manual - Page 7
    ... setting Timer Program Recording ...26 MTS Broadcast Compatibility ...29 ADDITIONAL INFORMATION Remote Control for TOSHIBA TVs ...30 Before Calling Service Personnel ...31 Specifications ...33 Accessories ...33 Memo...34 LIMITED WARRANTY ......
  • Toshiba W528 | Owners Manual - Page 8
    INTRODUCTION Identification of Controls See the page in for details. This manual shows the names of buttons in italics. Front ...jack Remote Sensor 20 20 20 20 REW PLAY FF STOP VCR Display 25 CHANNEL Front Panel model W-522 15 ...REC 19 EJECT CHANNEL 25 VCR Display Remote Sensor 20 20 20 ...
  • Toshiba W528 | Owners Manual - Page 9
    Remote Control To operate your TV. To operate this VCR. TV 30 VCR TV POWER VCR 15 1 2 ...are used to control the cursor on the screen. VCR Display Cassette indicator Timer recording indicator TIMER VCR Hi-Fi Hi-Fi indicator (only for model W-528/W-522) VCR indicator Multifunctional indicator ...
  • Toshiba W528 | Owners Manual - Page 10
    ... If the connected equipment is monaural (has one audio output jack), connect the L (MONO) side, the same sound is recorded on both L and R on the Hi-Fi track. Rear Panel model W-422 RF IN (FROM ANT.) terminal LINE OUT AUDIO jack LINE IN AUDIO jack IN (FROM ...
  • Toshiba W528 | Owners Manual - Page 11
    ...3 Close the battery compartment lid. 4 Point the remote control at the VCR and press the buttons within the operating range. Distance: within about 7 m from the front of the remote sensor ... remote control • Do not expose the remote sensor of the VCR to a strong light source such as...
  • Toshiba W528 | Owners Manual - Page 12
    ... only UHF antenna only Model:W-528 W-522 1 2 Model:W-422 Setting the VCR Output Channel When the... on your TV. For the video input mode, refer to the manual of your TV. VIDEO IN IN (FROM ANT.) OUT RF (...to record a channel while watching another, press TV/VCR on the remote control to turn off the ...
  • Toshiba W528 | Owners Manual - Page 13
    ... box and select cable channel 3 or 4 according to the output channel of the VCR. • to record a channel while watching another, press TV/VCR on the remote control to turn off the "VCR... will need to: • press I.SELECT so that the VCR display shows "L1" for W-528/W-522,"L" for W-422. 13
  • Toshiba W528 | Owners Manual - Page 14
    ...'s clock and tuner channels are set automatically when the VCR is plugged into the AC outlet. Auto Set ... TV POWER 1 4 7 A.SELECT 2 5 8 0 3 6 CM SKIP 1 Plug the VCR into the AC outlet 2 "Auto" blink while ... Auto set up has been completed, the VCR is on standby mode. Notes • It may takes several ...
  • Toshiba W528 | Owners Manual - Page 15
    ... and clock setting must be set first when VCR is first plugged in or after it encounters a power ... made the Audio/Video connection (page 12). • Press VCR to set the remote control operating ...SELECT 2 5 8 0 3 6 CM SKIP 1 2 Press POWER to turn on the VCR. Press PROG.. The following screen appears ...
  • Toshiba W528 | Owners Manual - Page 16
    ... to start the "AUTO" clock set feature. After the VCR is turned off, it automatically updates the clock using ... to step 8. MANU: You can set the clock manually. If you select "MANU" mode, ...'t know the clock data channel, select "AUTO". The VCR will scan automatically to tune the channel carrying the ...
  • Toshiba W528 | Owners Manual - Page 17
    ... if "L1 / L2"( For W-528/W-522 only ) or "L"( For W-422 only) is displayed in the VCR display. PREPARATION Incoming Antenna/Cable(CATV) Signals VCR TV POWER 1 4 7 A.SELECT 2 5 8 0 3 6 CM SKIP ... or STOP, and press FF to set to "ON". The VCR starts scanning and the channels are stored ...
  • Toshiba W528 | Owners Manual - Page 18
    ...100. • Each number button needs to be pressed within 2 seconds. CH/TRK buttons To shift up or down the stored channel numbers. To erase channels Channel reference chart Number on the VCR Corresponding channel number 10 10 10 31 31 R 11 11 11 32 32 S 12 12 12 33 33 T 13 13 13 34 34 U 55 55 SS 14 ...
  • Toshiba W528 | Owners Manual - Page 19
    ... with the window side facing up and the label side towards the front. The VCR is automatically turned on. The indicator will appear in the VCR display. PREPARATION Ejecting a cassette Press EJECT. The cassette is ejected from the cassette compartment. Warning Do not ...
  • Toshiba W528 | Owners Manual - Page 20
    ... one of CH/TRK to adjust the tracking manually. Notes • During the adjusting, the playback picture ... on the tape used, especially when the tape was recorded on another VCR. S-VHS Quasi Playback (SQPB... the same quality and resolution as the original S-VHS playback picture. • This VCR cannot record...
  • Toshiba W528 | Owners Manual - Page 21
    ... Playback You can play back a tape at various tape speeds. Picture Search VCR TV POWER A tape runs at 5 times or 7 times the normal playback ... ) and then return to normal playback. 1 Press CM SKIP during playback. The VCR will automatically search forward for 30 seconds to a maximum of 3 minutes ...
  • Toshiba W528 | Owners Manual - Page 22
    ... after about 5 minutes and returns to normal playback. • The slow-motion picture may flicker up and down. This is not a defect in the unit. Adjusting the Tracking Manually If the slow-motion picture is noisy, hold down one of CH/TRK until the best picture is obtained. Note The noise in the slow-...
  • Toshiba W528 | Owners Manual - Page 23
    ... not work on non-recorded portions on the tape. • When the tape is ejected or the VCR is turned off, the display changes to clock. • If the .... to exit. Press REMAIN/COUNTER. The remaining time ("R - : - -") appears in the VCR display. Notes • The displayed remaining time is an approximation. ...
  • Toshiba W528 | Owners Manual - Page 24
    Memory Stop Feature (Zero Return) VCR TV POWER 1 ENTER 1 4 7 A.SELECT 2 5 8 0 3 6 CM ...Notes: If you are rewinding the tape and the VCR stops at "0H00M00S M", press REW again ...0H00M00S M" between that point and the end of the tape, the VCR will continue to fastforward to the end of the tape. COUNT...
  • Toshiba W528 | Owners Manual - Page 25
    ...the VCR, or CH/TRK or number buttons on the remote control. 9 100 VCR EJECT PLAY RECORDING REW... see "L1/ L2" (For W-528/W-522 only), or "L" (For W-422 only) in the VCR display, pressISELECT so that ... simultaneously press both REC on the remote control. Recording starts. VCR REC TIMER TIMER S...
  • Toshiba W528 | Owners Manual - Page 26
    ...is set correctly (page 16). • Store the channels on the VCR (pages 17 and 18). Timer Programming Procedure VCR TV POWER 1 4 7 A.SELECT 2 5 8 0 3 6 CM SKIP 9 100 Number buttons ENTER ...• You can make "L1/L2"(For W-528/W-522 only) or " L" (For W-422 only) appear on the channel number...
  • Toshiba W528 | Owners Manual - Page 27
    ... completed. Press both TIMER simultaneously. The power turns off and the VCR enters the timer standby mode. REC TIMER TIMERHi-Fi STEREO L SAP If you... to "AUTO". Recording starts in the SP tape speed and the VCR automatically selects the tape speed to record the program to ...
  • Toshiba W528 | Owners Manual - Page 28
    ... turn it off, and then turn the VCR on by pressing VCR POWER. 2) With steps 2 to 9, change the items....) Error indication The "--E-" ( Error ) indicator appears in the VCR display if you press both ... By pressing the POWER button on the front panel of the VCR, it will cancel the timer recording and go ...
  • Toshiba W528 | Owners Manual - Page 29
    RECORDING MTS Broadcast Compatibility ( For W-528/W-522 only ) This VCR can receive or record MTS (Multichannel TV Sound) broadcasts. By connecting the VCR to your stereo system or stereo TV, you ... MONO (MIXED) MONO MONO MONO MONO (MIXED) Hi-Fi sound track L MONO R MONO STEREO MONO ...
  • Toshiba W528 | Owners Manual - Page 30
    ADDITIONAL INFORMATION Remote Control for TOSHIBA TVs The remote control can control TOSHIBA TVs. 1 POWER CH/TRK CM SKIP VCR TV POWER TOSHIBA TV's Control 1 4 7 A.SELECT 2 5 8 0 3 6 9 100 EJECT 100 Number buttons FF 1 2 Press TV to set the ...
  • Toshiba W528 | Owners Manual - Page 31
    ... cassette. - Load a cassette. (page 19) Noise is present in the Hi-Fi sound being played. • Tracking is not set appropriately. - Adjust the tracking manually. (page 20) The clock does not work. • There has been a power failure. - Reset the...
  • Toshiba W528 | Owners Manual - Page 32
    ...range. - Make sure the remote control is within 30° of the remote sensor on the VCR. (page 11) • Too far from the VCR. - Use the remote control within 7 m from the front of the VCR. (page 11)...obstacle. • The operating mode of the remote control is not set correctly. - Press VCR or TV depending...
  • Toshiba W528 | Owners Manual - Page 33
    ...125 UHF/VHF: 75 Ω F type connector Standard NTSC Recording: VHS format (SP, SLP) Playback: VHS format... output: Audio input: Audio output: Audio frequency range (Hi-Fi): Audio dynamic range ( Hi-Fi): Utilization conditions: ADDITIONAL INFORMATION Accessories Antenna cable ...1 Remote control ...1 ...
  • Toshiba W528 | Owners Manual - Page 34
    ... Toshiba America Consumer Products, Inc. ("TACP") and Toshiba Hawaii Inc. ("THI") make the following limited warranties. ...90) day warranty for all parts and labor. Owner's Manual and Demographic Card You should read the owner's manual thoroughly before operating this product. You should complete and ...
  • Toshiba W528 | Owners Manual - Page 35
    LIMITED WARRANTY (continued) How to Obtain Warranty Service (1)Refer to the troubleshooting guide in your owner's manual. This check list may solve your problem. (2)Call the TACP toll free number 800-631-3811 within (30) days after ...



Type your new search above

The manual viewer requires the flash plugin to be installed and enabled.
To view this page ensure that Adobe Flash Player version 10 or greater is installed.

Toshiba W528 Manual