Toshiba W528 Owners Manual - Page 25

RECORDING RECORDING Recording a TV Program This section explains the basic recording operation. Preparation • Select the video channel (3 or 4) or video input mode on the TV. Basic Recording VCR TV POWER 1 23 456 CM SKIP 7 89 A.SELECT 0 100 3 1 Load a cassette with the safety tab attached. 2 Press TV/VCR so that the "VCR" indicator appears in the VCR display. VCR EJECT PLAY REW FF ENTER STOP SLOW PAUSE/STILL REMAIN/ COUNT DISPLAY COUNTER RESET SP/ SLP I.SELECT REC TIMER TV VOL PROG. CANCEL 2 6 4 5 I.SELECT 3 Select a channel to record with CHANNEL on the VCR, or CH/TRK VCR or number buttons on the remote control. If you see "L1/ L2" (For W-528/W-522 only), or "L" (For W-422 only) in the VCR display, pressISELECT so that the channel number appears. • If you record cable channels via the cable box, make the output channel number of the cable box or "L1"(For W-528/W-522 only), "L" (For W-422 only) appear, depending on your connection. (See pages 12 - 13). To record from other connected equipment In step 3, press I.SELECT to 4 Press SP/SLP to select the recording tape speed. SP: Suitable for general recording with TIMER VCR REC switch the display as follows: better picture and sound quality. W-528/W-522 : SLP: Suitable for tripling recording time, but with less picture and L1: To record via the LINE IN sound quality than using the SP tape speed. 1 jacks on the rear panel. 5 L2: To record via the LINE IN Press REC on the VCR, or 2 jacks on the front panel. W-422 : L : To record via the LINE IN simultaneously press both REC on the remote control. jacks on the rear panel. Recording starts. REC TIMER VCR TIMER S L 6 Press STOP to stop recording. Watching a TV program while recording another 1) While recording, press TV/VCR to turn off "VCR" indicator. 2) Choose another channel using the channel selector on the TV. Skipping unnecessary scenes while recording Press PAUSE/STILL to stop recording momentarily. To resume recording, press PAUSE/STILL again. Note The VCR automatically shifts to the stop mode if the recording pause mode continues for 10 minutes. Recording off time setting By setting the recording off time, the recording stops and the VCR is turned off automatically. While recording, press simultaneously both REC on the remote repeatedly to set the desired off time. Each time you press REC, each half-hour up to about 4 hours appear cyclically. VCR Notes • To cancel the recording in progress, press POWER on the VCR. 25