Tripp Lite 9PX11KTF11M Eaton 9PX UPS 700-3000 VA 2U Owners Manual - Page 16

2. Presentation Com settings Submenu Output signals Available settings [Relay] [DB9-1] [DB9-7] [DB9-8] Sets events or fault that will actuate Output signal parameters through external contact connector or RS232 port Default settings [Relay]: [On bat] [Low bat] [Bat fault] [Bypass] [UPS OK] [Load protected] [Load powered] [General alarm] [Ext. charger ON] [OVL pre-alarm] [Relay] [Bypass] [DB9-1]: [On bat] [Low bat] [Bat fault] [Bypass] [UPS OK] [Load protected] [Load powered] [General alarm] [Ext. charger ON] [OVL pre-alarm] [DB9-1] [Low bat] [DB9-7]: [On bat] [Low bat] [Bat fault] [Bypass] [UPS OK] [Load protected] [Load powered] [General alarm] [Ext. charger ON] [OVL pre-alarm] [DB9-7] [UPS OK] Remote command Shutdown commands On battery notice delay General alarm [DB9-8]: [On bat] [Low bat] [Bat fault] [DB9-8] [On bat] [Bypass] [UPS OK] [Load protected] [Load powered] [General alarm] [Ext. charger ON] [OVL pre-alarm] [Enabled] [Disabled] [Enabled] If Enabled, shutdown or restart commands from software are authorized. [Send CMD] [Output OFF] [OFF delay] [restart] Sets events or fault that will actuate Output signal parameters through external contact connector or RS232 port [Send CMD]: [Yes] [No] Send CMD: [No] [Output OFF]: [No] [UPS] [Group 1] Output OFF: [No] [Group 2] [Group 1 + Group 2] [OFF delay]: [0s] ...[999s] OFF delay: [0s] [Restart]: [Yes] [No] Restart: [Yes] [0s] ... [99s] [0s] Sets delay before noticing on battery information to software. [On battery] [Battery fault] [Internal fault] [Overload pre-alarm] [Internal fault] [Ambient temp.] [Fan lock] [Bypass overload] [Current limit] [Short circuit] [Inverter overload] [Power overload] [Low battery] [On bypass] [UPS OK] [Load protected] [Load powered] [Ext. charger ON] Defines which event or fault generate a general alarm through Output signal screen. Page 16 9PX 1-3 KVA US_EN