Troy-Bilt Storm Tracker 2690 Operation Manual - Page 15
Starting and Stopping the Engine, To Engage Drive, To Engage Augers, To Steer, Engage Heated Grips,
View all Troy-Bilt Storm Tracker 2690 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Operation 5 Starting and Stopping the Engine Refer to the Engine Operator's Manual packed with your snow thrower for instructions on starting and stopping the engine. To Engage Drive 1. With the throttle control in the Fast (rabbit) position, move the shift lever into one of the six forward (F) positions or two reverse (R) positions. Select a speed appropriate for the snow conditions and a pace you are comfortable with. 2. Squeeze the drive control against the handle and the snow thrower will move. Release it and the drive motion will stop. To Engage Augers To engage the augers and start throwing snow, squeeze the auger control against the left handle. Release to stop the augers. To Steer With the drive control engaged, squeeze the right steering trigger control to turn right. Squeeze the left steering trigger control to turn left. Engage Heated Grips To activate the heated grips, move the switch found on the rear of the dash panel into the ON position. See Fig. 5-1. Caution: It is recommended that you wear gloves when using the heated grip. If the heated grip becomes too hot, turn it off. Set Track Position Move the track lock lever to the right, then forward or backward to one of the three positions. See Fig. 5-2. NOTE: When positioning the track lock lever into one of the three operating locations, apply a downward force on the right handle with your left hand while you shift the track lock lever into the desired position with your right hand. Top View Track Lock Lever Packed Snow Normal Snow Transport Figure 5-2 Figure 5-1 15