Viking 18%20Inch%20H.%20Chimney%20Wall%20Hood Installation Instructions - Page 15
Installation
View all Viking 18%20Inch%20H.%20Chimney%20Wall%20Hood manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Installation (VWH 10" H./12"H. Wall Hoods w/Standard Ventilator) 1 2 Check damper for unrestricted movement, adjust if necessary. 3 Flip hood over and remove electrical box cover. 4 2 1 Attach transition to damper. Seal with aluminum tape. WARNING To reduce the risk of fire, electric shock, or injury to persons, observe the following: • Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. • Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. 5 1 Insert 6" of electrical wiring through the top of vent hood and secure using wiring restrain. Refer to local codes. 28 Slide duct over transition and tape around joint. 6 5/16" nut driver CAUTION: Secure vent hood to wall using screws provided. Use additional mounting screws and wall anchors, if necessary. 7 BARE OR GREEN WHITE WHITE GREEN BLACK BLACK 5/16" nut driver CAUTION: If not using a duct cover, using screws provided, make sure top mounting screws are secured into soffit or cabinet framing. Use additional mounting screws, if necessary. 8 1 1 2 Connect black to black, white to white, and the green/bare wire under the green screw. NOTE: Housing wiring must be properly installed for wiring to be correct when wiring unit. 9 1 Replace electrical box cover. Make connection to breaker box. 10 1 1 3 2 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. 3 2 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. 29