Viking 18%20Inch%20H.%20Chimney%20Wall%20Hood Installation Instructions - Page 17

Installation (con't) (VWH 10" H./12"H. Wall Hoods w/Recirculating Kit) 8 BARE OR GREEN WHITE WHITE GREEN BLACK BLACK 9 1 1 2 Connect black to black, white to white, and the green/bare wire under the green screw. NOTE: Housing wiring must be properly installed for wiring to be correct when wiring unit. 10 Replace electrical box cover. Make connection to breaker box. 11 1 Assemble brackets to baffles and insert charcoal filters. 12 1 2 3 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. 13 1 3 2 Slide spacer front over front lip. Push spacer rear up, then slide back over rear lip. 3 2 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. 32 Installation (VWH 18"H. Wall & VCWH Chimney Wall Hoods) 1 1-1/2"x 3/4" (3.8 cm) x (1.9 cm) wood strip 1(4-.163c/1m6)" 5/16" nut driver 2 Slot for wood strip 5/16" nut driver Measure down 1-13/16 (4.6 cm) from desired height of hood and secure 1-1/2" x 3/4" wood strip (provided locally) to wall using screws provided. 3 5/16" nut driver Use additional mounting screws to secure hood to wood strip. 5/16" nut driver CAUTION: Secure vent hood to wall using screws provided. Use additional mounting screws and wall anchors, if necessary. 4 1 CAUTION: If not using a duct cover, using screws provided, make sure top mounting screws are secured into soffit or cabinet framing use additional mounting screws, if necessary. 5 1 1 3 2 Slide filter front over front lip. Push filter rear up, then slide back over rear lip. 33 3 2 Slide filter front over front lip. Push filter rear up, then slide back over rear lip.