Vtech 1739 User Manual - Page 11

Remote operation Feature summary (continued) FUNCTION: COMMAND: End remote access call Press 9. The system announces "The machine will now hang up," and disconnects the call. NOTE: If no commands are entered within 15 seconds, the system announces, "The machine will now hang up," and then disconnects the call In case of difficulty If you have difficulty operating this answering system, try the suggestions below. For customer service, or to purchase accessories or obtain replacement parts, visit our website at www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial 1 (866) 288-4268. Please retain your receipt as your proof of purchase. Messages are incomplete. • The system can record messages of up to 3 minutes. • If a caller leaves a long message, part of it might be lost when the system disconnects the call after 3 minutes. • If the memory is full when recording a message, the system stops and disconnects the call. The system does not answer after the correct number of rings. • If the toll saver feature is on, the number of rings changes from 4 to 2, or 6 to 4, when there are new messages waiting. • In some cases, the system might be affected by the ringing system used by the telephone service provider. • If the system's memory is full or the system is off, the system answers after 10 rings. • If the system is in feature setup mode and a call comes in, it will not answer the call until you press PLAY/STOP or the setup timeout has elapsed. The system does not record messages. • When the memory is full, some saved messages must be deleted before new messages can be recorded. Incoming messages are not heard during recording. • Press VOLUME until the desired volume is reached. 10