Vtech 5105 User Manual - Page 8

Setup

Get Vtech 5105 PDF manuals and user guides View all Vtech 5105 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

Getting Started Setup Installation of Battery Pack in Handset Follow the steps below: 1. Remove the battery cover by pressing on the indent and sliding downward. 2. Align the two holes in plug with the socket pins. Insert the plug into socket. Place the battery pack into the compartment with the wires in one of the bottom corners of the battery pack. 3. Replace the battery cover by sliding it upwards. 4. If the new battery pack is not already charged, place the Handset in the Base unit, or a remote charging stand, and allow it to charge for 12 hours. After initial charge, a maintenance charge of 8 hours should be sufficient. The original Handset that is shipped with your v 2656 system will be automatically registered to the Base. This Handset is HANDSET 1. As you register additional Handsets to the system, they will be assigned extension numbers in the following order: HANDSET 2, HANDSET 3, and finally HANDSET 4. After a Handset battery pack is installed, the Handset will automatically begin SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER BASE ID to register the new Handset. 91-005358-050-000 v2656.pmd 8 8 8/5/2004, 4:51 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
8
Setup
Getting Started
Follow the steps below:
1.
Remove the battery cover by pressing
on the indent and sliding downward.
2.
Align the two holes in plug with the
socket pins. Insert the plug into
socket. Place the battery pack into
the compartment with the wires in one
of the bottom corners of the battery
pack.
3.
Replace the battery cover by sliding
it upwards.
4.
If the new battery pack is not already
charged, place the Handset in the
Base unit, or a remote charging
stand, and allow it to charge for 12
hours. After initial charge, a
maintenance charge of 8 hours should
be sufficient.
The original Handset that is shipped with your
v 2656
system will be
automatically registered to the Base. This Handset is
HANDSET 1
.
As you register additional Handsets to the system, they will be assigned extension
numbers in the following order:
HANDSET 2
,
HANDSET 3
, and finally
HANDSET 4
.
After a Handset battery pack is installed, the Handset will automatically begin
SEARCHING FOR
BASE
(if previously registered), or it will prompt you to
ENTER BASE ID
to register the new Handset.
Installation of Battery Pack in Handset
91-005358-050-000 v2656.pmd
8/5/2004, 4:51 PM
8