Vtech VT20-2481 User Manual - Page 7

Gettng Started Getting Started Registration and Operation Registration And Operation Of The VTech VT20-2420 Accessory Handset Your VTech GIGAPHONE system can operate up to 8 Handsets. The VTECH accessory Handset consists of the following: 1 3 5 Setup Of The VT20-2420 Accessory Handset 1. Plug the AC power adapter into an electrical outlet. 2. Remove the Handset battery cover by pressing on the indent and sliding downward. 3. Place the new battery pack in the Handset, with the metal contacts aligned with the charge contacts in the battery compartment. 4. Replace the battery cover by sliding it upward. 5. Place the Handset in the Charge Cradle, and allow it to charge for 12 hours. After the initial charge, a maintenance charge of 8 hours should be sufficient. 12 Registration and Operation Enter Base ID Code 1. After charging the Handset, remove it from its Charge Cradle; the screen will display: OK alternating with this screen: 2. If, after charging the Handset, you see: 3. Press NEW. You will now see the ENTER BASE ID screen as described in step 1. 4. Find the BASE ID Code by doing the following: (the Base must be in idle (OFF) mode) A. At the Base, press MENU B. Scroll down to DISPLAY BASE-ID C. Press OK. The Base screen will display the 15-digit ID Code. Afterwards, it will return the idle screen. 5. Enter the 15-digit Base ID Code into the Handset; then press OK. NEW MENU 6. Wait approximately 15 to 60 seconds. You will hear confirmation beeps from the Base and Handset. The newly registered Handset will now assign itself the lowest handset number not previously assigned to a different system Handset (1 through 8). 7. If the Handset displays REJECTED BY BASE or continues to display SEARCHING FOR BASE for well beyond 60 seconds, try the registration process again by repeating the above steps. Congratulations! You can now enjoy the benefits of your 2-Line VTECH MultiHandset system. 13