Vtech VT6897 User Manual - Page 46

Batteries Battery care and performance After the battery is fully charged, you can expect the following performance: Operation While in use (talking) Operating time up to 7.5 hours While not in use (standby*) up to 3.5 days * Handset is off the telephone base or charger but not in use. • The battery needs charging when: - A new battery is installed in the handset. - The phone beeps twice every five seconds. - The screen displays LOW BATTERY and the low battery icon. • Place the handset in the telephone base so the CHARGE light turns on. The battery is usually fully charged in about 16 hours. • You can keep the battery fully charged by returning the handset to the telephone base after each use. Replace the handset battery 1. Remove the battery compartment cover on the handset by pressing on the indentation and sliding the cover downward. 2. Lift out the old battery and disconnect. 3. Align the two holes in the new battery's plug with the socket pins, and snap the plug into place. Snap the battery in the compartment, as described in Installation, on page 7. 4. Replace the cover by sliding it up into place. 5. The new battery must be fully charged before installing it into the phone. Place the handset in the telephone base and allow it to charge for at least 16 hours the first charge. The telephone might operate before that, but for best performance, let the battery charge fully. www.vtechphones.com • If you repeatedly get a low battery indicator, even after charging overnight, the battery should be replaced. • To reduce the risk of fire or injury to persons or damage to the telephone, charge the battery provided with this product only in accordance with the instructions and limitations specified in the user's manual. 45 Basic operation