Weider 244 Bench Uk Manual - Page 9

11. Orient the Left Fly Arm (25) so that the short side of the pivot tube is on the side shown. Tap two 30mm Square Inner Caps (22) into the ends of the Fly Arm. Press a 25mm Round Inner Cap (24) into the weight tube on the Fly Arm. Slide a Weight Stop (28) onto the weight tube. Tap a Fly Arm Stop (15) onto the welded tube on the indicated Upright (1). Press two Plastic Bushings (14) into the indicated holes in the Upright. Attach the Left Fly Arm (25) to the Upright with an M10 x 130mm Bolt (19) and a Butterfly Knob (13). Make sure that the lower end of the Fly Arm is on the outside of the Fly Arm Stop. Repeat this step with the Right Fly Arm (not shown) and the other Upright. 12. Press two 19mm Round Inner Caps (9) into the ends of a Short Pad Tube (12). Insert the Short Pad Tube into the indicated hole in the Left Fly Arm (25) from the side shown. Slide a Short Foam Pad (27) onto the Short Pad Tube. Repeat this step for the Right Fly Arm (not shown). 11 13 14 14 19 28 Short Side of Pivot Tube 22 1 25 15 22 Weight Tube 24 12 9 12 9 25 27 13. Route the eyelet end of the Cable (39) under the indicated bar and over the Pulley (44). Attach the Pulley and a pair of Pulley Covers (43) inside of the Lat Tower (40) with an M10 x 55mm Bolt (42) and an M10 Nylon Locknut (33). Make sure the small tabs on the Pulley Covers are in the indicated location. Press a 25mm Round Inner Cap (24) into each end of the weight tube on the Weight Carriage (48). Press Square Bushings (47) onto the top and bottom of the Weight Carriage. Slide two Weight Stops (28) onto the weight tube. Insert the M8 x 16mm Bolt (45) into the bracket on the Weight Carriage (48) from the direction shown. Slide the Weight Carriage onto the Lat Tower (40). Attach the Cable (39) to the Bolt in the Weight Carriage with an M8 Nylon Locknut (17). Do not overtighten the Locknut; the Cable must be able to pivot freely. 13 42 Small Tab 43 44 43 40 39 17 28 24 Bracket 47 9 Bar 39 33 47 45 48 24 28