Weider 9350 Instruction Manual - Page 10

11. Press two 38mm Square Inner Caps (32) into the 11 end of the Seat Frame (36). Attach the Bumper (87) to the Seat Frame (36) with the M5 x 25mm Self-tapping Screw (80). 36 32 32 87 80 12. Attach the Seat Frame (36) to the Front Upright 12 (42) with the M10 x 80mm Carriage Bolt (99) and the Seat Knob (49). 99 42 49 36 13. Press two 38mm Square Inner Caps (32) into the 13 ends of the Leg Lever (29). Lubricate an M10 x 63mm Bolt (107) with grease. Attach the Leg Lever (29) to the Seat Frame (36) with the Bolt and an M10 Nylon Locknut (21). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily. 107 36 Lubricate 32 21 29 32 14. Press a 50mm Square Inner Cap (44) into the 14 end of the Left Butterfly Arm (47). Press a Sleeve (105) into the round tube on the Left Butterfly Arm. Wet the lower end of the Left Butterfly Arm (47) with soapy water. Slide a Large Foam Pad (45) onto the Left Butterfly Arm. Repeat this step with the Right Butterfly Arm (not shown). 10 105 47 45 44 Seat Assembly 45 45. Attach the Shroud (59) to the bracket on the Top Frame (55) with two M6 Washers (78) and two M6 x 16mm Bolts (18). Attach the Shroud (59) to the bracket on the Base (4) with two M6 Washers (78) and two M6 x 16mm Bolts (18). 18 78 59 55 18 78 18 78 46. Insert the M6 x 50mm Carriage Bolt (38) into the 46 centre hole in the Seat Plate (37). Attach the wide end of the Seat (13) to the Seat Plate with two M6 x 16mm Bolts (18). Attach the Seat Plate (37) to the Seat Frame (36) with the M6 x 50mm Carriage Bolt (38), an M6 Washer (78), and the M6 Nylon Locknut (2). Attach the other end of the Seat (13) to the Seat Frame (36) with an M6 x 50mm Screw (33) and an M6 Washer (78). 47. Attach the Backrest (41) to the Front Upright (42) 47 with two M6 x 73mm Screws (43) and two M6 Washers (78). 18 78 4 13 36 38 37 18 78 33 78 2 43 78 43 78 42 41 19