Weider 9645 Instruction Manual - Page 10

ARM ASSEMBLY SEAT ASSEMBLY 15. See the inset drawing. Attach the Military 15 Press Arm (84) to the Pivot Arm (101) with two 5/16" x 2 1/4" Bolts (33) and two 5/16" Nylon Locknuts (3). Press two 1 1/2" Square Inner Caps (32) into the Military Press Arm (84). Press two 1" Round Inner Caps (49) into the Military Press 21 Arm. Slide two 5" Plastic Handgrips (83) onto the Military Press Arm. Attach the Pivot Arm (101) to the Assist Upright (74) with a 3/8" x 3 1/4" Bolt (67) and a 3/8" Nylon Locknut (21). 74 32 49 32 101 84 83 67 56 16. Press two 1" x 2" Inner Caps (107) into the Assist Arm (105). 16 Attach the Assist Arm (105) to the Leg Press Upright (56) with a 3/8" x 6" Bolt (106), two 3/8" Flat Washers (9), and a 3/8" Nylon Locknut (21). See the inset drawing. The Assist Arm must be attached to the lowest hole in the Leg Press Upright (56). The Assist Arm must also be below the welded bracket on the Assist Upright (74). 33 101 84 3 Bracket 105 74 56 56 74 106 107 9 9 105 21 10 40. Locate and open the parts bag labelled 40 "SEAT ASSEMBLY." Insert a 1/4" x 2 1/2" Carriage Bolt (92) through the centre hole in a Seat Plate (37). Attach the Seat Plate to the Rear Backrest 85 (85) with two 1/4" x 1/2" Screws (18). 56 Insert the 1/4" x 2 1/2" Carriage Bolt (92) through the indicated hole in the Leg Press Upright (56). Tighten a 1/4" Nylon Locknut (2) with a 1/4" Flat Washer (10) onto the Carriage Bolt. Attach the top of the Rear Backrest (85) to the Leg Press Upright with a 1/4" x 2 1/2" Screw (43) and a 1/4" Flat Washer (10). 43 10 37 92 18 2 41. Attach one end of a Seat (13) to the Rear Seat Frame (100) with two 1/4" x 1/2" Screws 41 (18). Attach the other end of the Seat to the Rear Seat Frame with a 1/4" Flat Washer (10) and a 1/4" x 2 1/2" Screw (43). 13 100 18 42. Attach the Assist Seat (104) and the Angle Bracket (110) to the Assist Arm (105) with four 1/4" Flat Washers (10) and four 1/4" x 2 1/2" Screws (43). 42 104 110 105 10 19 18 10 43 10 43