Weider Club 16.4st English Manual - Page 17
Locate the Leg Press Cable 78.
View all Weider Club 16.4st manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
CABLE ASSEMBLY 35. Locate the Leg Press Cable (78). Attach the end of the Leg Press Cable to the Long ÒUÓBracket (57) with a 1/4Ó Nylon Locknut (2) and a 1/4Ó Flat Washer (10). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing. Wrap the Leg Press Cable (78) around a 3 1/2Ó Pulley (15). Attach the Pulley to the Leg Press Upright (56) with the 3/8Ó x 3 3/4Ó Bolt (88), a 3/8Ó Flat Washer (9), and a 3/8Ó Nylon Locknut (21). Be sure that the Cable and Pulley move smoothly and that the Cable is between the Pulley and the welded rod. The ball on the Cable must be on the indicated side of the Pulley. 35 2 10 57 15 88 78 Welded Rod 56 Ball 9 21 78 36. Attach the Press Bracket (94) to the Leg Press Arm (96) with a 3/8Ó x 3Ó Bolt (100) and 36 a 3/8Ó Nylon Jam Nut (99). Wrap the Leg Press Cable (78) around a 3 1/2Ó Pulley (15). Attach the Pulley to the Press Bracket (94) with a 3/8Ó x 2Ó Bolt (12) and a 3/8Ó Nylon Locknut (21). Slide a 5/16Ó Flat Washer (8) onto a 5/16Ó x 2 3/4Ó Bolt (11). Insert the Bolt through the center hole in the Leg Press Seat Frame (79) from the indicated side. (Note: The three holes are for cable adjustment.) Tighten a 5/16Ó Flat Washer (8) and a 5/16Ó Nylon Jam Nut (93) onto the Bolt. Slide the end of the Leg Press Cable (78) onto the end of the Bolt. Thread another 5/16Ó Nylon Jam Nut (93) onto the Bolt. Do not fully tighten the second Jam Nut. There must be room between the two Jam Nuts for the end of the Cable to pivot. 2 10 57 96 12 11 99 8 78 94 100 15 8 21 79 93 17