Weider Club 16.4st English Manual - Page 22
Attaching And Removing The Seat, Attaching The Leg Lever To The Low, Pulley Station, Adjusting
View all Weider Club 16.4st manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
ATTACHING AND REMOVING THE SEAT To attach the Seat (13), set the bracket on the Front Seat Frame (36) onto the indicated pins on the Front Upright (42). Attach the Seat Frame to the Front Upright with the 5/16Ó x 2 3/4Ó Carriage Bolt (14), 3/16Ó Flat Washer (8) and the Seat Knob (40). For some exercises, the Seat (13) must be removed. First, be sure that the chain is not attached to the leg lever. Next, remove the Seat Knob (40), 3/16Ó Flat Washer (8) and the 5/16Ó x 2 3/4Ó Carriage Bolt (14) from the Front Seat Frame (36). Lift the Front Seat Frame off the Front Upright (42). ATTACHING THE LEG LEVER TO THE LOW PULLEY STATION To use the Leg Lever (29), the seat must be attached to the Front Upright (42) (see ATTACHING AND REMOVING THE SEAT above). Attach one end of the Chain (52) to the Low Cable (23) with a Cable Clip (53). Attach the other end of the Chain to the Eyebolt (35) with a Cable Clip. ADJUSTING THE LEG PRESS PLATE Remove the Press Pin (97) from the Leg Press Plate (95) and the Leg Press Arm (96). Align the welded tubes on the Leg Press Plate (95) with the desired set of holes in the Leg Press Arm (96). Re-insert the Press Pin (97) through the welded tubes on Leg Press Plate and the holes in the Leg Press Arm. 8 40 36 13 42 14 Pin 42 23 53 52 29 35 53 Welded Tube 96 95 97 22