Weider Club 560 English Manual - Page 10
Press a 60mm Square Inner Cap 57 into the Left - weight set
View all Weider Club 560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
14. Attach the Chin-up Bar (13) and two Joint Plates (6) to the Front Uprights (7) using four M10 x 78mm 14 6 Bolts (70) and four M10 Nylon Locknuts (68). Do not tighten the Nylon Locknuts yet. 70 13 68 6 7 68 15. Press a 60mm Square Inner Cap (57) into the Left Frame (12). Attach the Left Frame to the left Uprights (7, 8) using four M10 x 78mm Bolts (70) and four M10 Nylon Locknuts (68). Do not tighten the Nylon Locknuts yet. Assemble the Right Frame (10) to the right Uprights (7, 8) in the same manner. Attach the Center Frame (11) to the Left Frame (12) and the Right Frame (10) using four M10 x 78mm Bolts (70) and four M10 Nylon Locknuts (68). Tighten all Nylon Locknuts used in steps 10Ð15. 15 10 70 7 7 70 11 68 8 70 12 70 70 7 68 68 57 68 8 16. Press the two 51mm Round Inner Caps (89) into the weight tubes on the Weight Carriage (15). Press the two Carriage Bushings (16) into the Weight Carriage (15). Make sure the Weight Carriage is turned so the weight tubes are near the top, as shown. Attach the lower Carriage Bushing using an M10 x 66mm Bolt (74), two M10 Flat Washers (76), the 51mm Spacer (78), and an M10 Nylon Locknut (68). 16 89 16 68 76 16 15 Weight Tube 89 78 76 74 17. Set the two Weight Bumpers (18) over the indicated holes in the Weight Guide Base (4). Hold the 17 Weight Carriage (15) on top of the Weight Bumpers. Insert the two Weight Guides (9) into the Weight Carriage (15), the Weight Bumpers (18), and the Weight Guide Base (4). Attach the Weight Guides using two M8 x 72mm Bolts (72), four M8 Flat Washers (75), and two M8 Nylon Locknuts (69). 10 9 15 69 18 4 75 72