Weider Club 560 English Manual - Page 8

7. With the wide end of the Seat (27) positioned as shown, attach the Seat to the brackets on the 7 Wide End 27 Bench Frame (26) using four M6 x 16mm Screws (82). 26 82 8. Tap the six 3/4Ó Round Inner Caps (64) into the ends of the three Pad Tubes (35). 8 41 Insert the Pad Tubes (35) into the indicated holes in the Leg Lever (31) and the Bench Leg (30). Slide 64 31 two Foam Pads (41) onto each Pad Tube. 30 41 35 64 9. Attach the Curl Pad (29) to the Curl Post (28) with two M6 x 16mm Screws (82). 9 Slide the Curl Post (28) into the Bench Leg (30). Align one of the adjustment holes in the Curl Post with the adjustment hole in the Bench Leg. Tighten the Curl Post Adjustment Knob (90) into the holes in the Curl Post and the Bench Leg. Make sure you fully tighten the Curl Post Adjustment Knob. 29 82 90 28 30 10. Press 60mm Square Outer Caps (56) onto the ends of the Right and Left Bases (1, 3). Attach the Right and Left Bases (1, 3) to the Center Base (2) using four M10 x 78mm Bolts (70) and four M10 Nylon Locknuts (68). Do not tighten the Nylon Locknuts yet. 10 70 1 56 56 68 2 68 56 70 56 3 8