Weider Platinum Xp800 Canadian English Manual - Page 9
Tighten the M12 Nylon Locknuts 13 used
View all Weider Platinum Xp800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
8. Attach a Large Pulley (14) and the Pulley Plate 8 (68) to the Upright (2) with an M12 x 62mm Button Bolt (81) and an M12 Nylon Locknut (13). Do not tighten the Locknut yet. 68 13 14 81 2 9. Pull the Upper Cable (121), which is attached 9 inside of the Mech Frame (not shown), up between the Upright (2) and the Pulley Plate (68). Attach another Large Pulley (14) to the Upright (2) and Pulley Plate (68) with an M12 x 62mm Button Bolt (81) and an M12 Nylon Locknut (13). Make sure that the Upper Cable (121) is between the two Pulleys. Hold the 38mm Spacer (90) inside the loop of the Upper Cable (121), and between the Upright (2) and the Pulley Plate (68). Attach the Spacer with an M10 x 58mm Button Screw (11). Make sure the ends of the Cable do not wrap around each other below the Spacer and the Large Pulleys (14) used in steps 8 and 9 (see the CABLE DIAGRAM on page 18). Tighten the M12 Nylon Locknuts (13) used in steps 8 and 9. 10. Attach a Small Guide Spacer (18), a Large Guide 10 Spacer (17), and the two Crossbar Guides (15) to the Upright (2) with an M10 x 152mm Bolt (86). Pull the Upper Cable (121) up between the Crossbar Guides (15). Press the metal cover on the Cable into the groove in the Crossbar Block (16). Attach a Small Guide Spacer (18), the Crossbar Block, the two Crossbar Guides (15), an M10 Thick Washer (54), and the two Tethers (70) to the Upright (2) with another M10 x 152mm Bolt (86). Do not tighten the Bolt yet. 121 11 90 13 68 81 14 2 17 18 86 15 Metal 2 121 Cover 54 86 70 18 16 Groove 9