Weider Precision 200 English Manual - Page 13
Maintenance
View all Weider Precision 200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
MAINTENANCE Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immediately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents. TIGHTENING THE CABLES Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insert the weight pin (not shown) into the center of the weight stack (not shown). Next, locate the upper or lower U-bracket (18). Remove the M10 Nylon Locknut (57) and the M10 x 50mm Bolt (64) from the U-bracket, the 90mm Pulley (27), and the Cable Trap (51). Reattach the Pulley and the Cable Trap to the Ubracket using the hole closer to the center of the Ubracket. Make sure that the Cable Trap is in the proper position and that the High Cable (30) or the Low Cable (31) is between the Cable Trap and the Pulley. To further tighten the cables, move the 90mm Pulley (27) in the other U-bracket (18). 30 51 27 18 57 64 57 51 18 64 27 31 Do not overtighten the cables. If the cables are overtightened, the top weight will be lifted off the weight stack. If a cable tends to slip off the pulleys often, it may have become twisted. Remove the cable and reinstall it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual. 13