Weider Pro 900 Bench English Manual - Page 6

Assembly Before beginning assembly, carefully read the following information and instructions: ¥ Place all parts of the weight bench in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. ¥ Read each assembly step before you begin. ¥ For help identifying the small parts used in assembly, use the PART IDENTIFICATION CHART on the previous page. Note: Some small parts may have been pre-attached for shipping purposes. If a part is not in the parts bag, check to see if it has been pre-attached. ¥ Tighten all parts as you assemble them, unless instructed to do otherwise. ¥ As you assemble the weight bench, make sure that all parts are oriented as shown in the drawings. THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY: ¥ Two (2) adjustable wrenches ¥ One (1) phillips screwdriver ¥ One (1) rubber mallet ¥ Lubricant, such as grease or petroleum jelly, and soapy water will also be needed. Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. 1. Before assembling this weight bench, be sure that you have read and understand the information in the box above. The weight bench is designed to be used with a mid-width weight set (not included). To use the weight bench with an Olympic-size weight set, an optional Olympic expansion kit is available to purchase (model number 831.150780). Position the Crossbar (3) as shown. (Note: If you purchased the optional Olympic expansion kit, place the Olympic crossbar in place of the standard crossbar.) Attach the Crossbar to each Upright Base (7) with four M10 x 81mm Bolts (43), a Support Plate (20), and four M10 Nylon Locknuts (19). Note the position of the warning decal and make sure that the Upright Bases are oriented exactly as shown. Slide the Uprights (1) into the desired position in the Upright Base (7) and secure them with two M10 x 67mm Adjustment Knobs (37). 2. Slide the welded bracket on the Frame (2) onto the Crossbar (3). Secure the Frame with two M10 x 81mm Bolts (43) and two M10 Nylon Locknuts (19). 1 37 43 2 1 7 Warning 20 19 Decal 3 20 43 2 19 3 1 7 20 19 37 20 43 6