Weslo 605s Bike English Manual - Page 4

ASSEMBLY Assembly requires two people. Place all parts of the WESLO 605s in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Read through all steps before beginning. During assembly, make sure that all parts are oriented as shown in the drawings. Assembly requires the included tool and grease packet, an adjustable wrench mallet , a hammer and a phillips screwdriver , a rubber . 1. Insert the end of the Rear Stabilizer (34) into the Frame (46). Attach the Rear Stabilizer to the Frame with the four M5 x 12mm Screws 1 56 (56). 34 2. Turn the Front Stabilizer (59) so the indented holes are facing the floor. Attach the Front Stabilizer to the Frame (46) with two M8 x 48mm Carriage Bolts (57), two M8 Zinc Washers (43), and two Acorn Nuts (12). 2 12 43 46 46 43 3. Remove the three 8mm Zinc Locknuts (36) from the underside of the Seat (40). Attach the Seat to the top of the Seat Post (41) with the three Locknuts. Insert the Seat Post (41) into the Frame (46). Align one of the holes in the Seat Post with the hole in the Frame. Insert the Seat Knob (45) into the Frame and the Seat Post, and tighten the Seat Knob into the Frame. Make sure to insert the Seat Knob through one of the holes in the Seat Post; do not insert the Seat Knob under the Seat Post. 4. Apply a small amount of grease to the Pivot Shaft (17). Slide the Pivot Shaft into the Frame (46) and center it. Slide the Left Handlebar (10) onto the left end of the Pivot Shaft. Slide the Right Handlebar (not shown) onto the right end of the Pivot Shaft. Attach an M8 Zinc Washer (43) and an 8mm Zinc Locknut (36) to each end of the Pivot Shaft. 59 57 3 40 45 46 4 41 36 10 17 46 36 43 4