Weslo C8 Uk Manual - Page 9

6. Set the Console (68) face down on a soft surface to avoid scratching the Console. Identify the 6 Right Handrail (40), which has a large hole in the location shown. Hold the Right Handrail near the Console. Insert the console wire into the large hole in the Right Handrail and out of the top as shown. Next, attach the Right Handrail with three 3/4" Screws (3). Make sure that no wires are pinched. Start all three Screws before tightening any of them; do not overtighten the Screws. Next, attach the console ground wire to the Right Handrail (40) with a Silver Ground Screw (10). Attach the Left Handrail (not shown) to the Console (68) in the same way. Note: There are no wires on the left side of the Console. 3 40 Console Wire 3 3 Large Hole 68 10 Console Ground Wire 7. Locate the wire in the upper end of the Right Upright (39). Pull the wire until the end of the 7 Upright Wire (69) is extending from the Right Upright. Then, untie and discard the wire. Wire 69 39 8. Connect the Upright Wire (69) to the console wire. Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors and the excess wire into the Right Upright (39). 8 68 40 Next, insert the bracket on the Right Handrail (40) into the Right Upright (39) and insert the bracket on the Left Handrail (not shown) into the Left Upright (not shown). Make sure that no wires are pinched. Bracket 69 Console Wire 69 39 9