Weslo Cadence 975 English Manual - Page 8
few seconds
View all Weslo Cadence 975 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
DIAGRAM OF THE CONSOLE The heart of the treadmill is the state-of-the-art programmable console. The console offers both manual and program operation, and features an array of independent LED displays to give you continuous exercise feedback. Please read these instructions carefully before operating the console. Note: If there is a thin sheet of clear plastic on the face of the console, peel it off before operating the console. CURRENT SEGMENT U O -AU U O O O❑ U 16 O O❑O Ps U O O O O O 71 13 O O O O O 11 U OOOOO U O O O Si 11 O O O O O so Ti- "Tra O O O 43 11 CI O u 0 CI 411 LS O O O O O is VALI ^ w FITNESS RTNESS ION MEL LEYEL O MANUAL O MOUNTAIN In ULM os IA DO ItOGIANSTAIT TIME v , Ill! SIT SPEED w SPEED Bag SPEED Pulse Indicator WK? (MIRES O ?OM O 410114 aaa DISTANCE 10111 114164 INCLINE kmia anu. w INCLINE INCLINE STOP Safety Key/Clip Pulse Earclip Jack TURNING ON THE POWER If the safety key is in the console, remove it. Make sure that the on/off switch located near the power cord is in the "on" position (see the drawing at the right). Plug in the power cord (see PLUGGING IN THE POWER CORD on page 7). All displays and indicators on the console will flash three times. "on" Position Stand on the frame rails of the treadmill, find the clip attached by a cord to the safety key, and slide the clip onto the waistband of your clothing. A WARNING: Do not stand on the walking belt while turning on the power. Always wear the clip when operating the treadmill. Insert the safety key into the console. The indicator on the MANUAL button and the five displays on the right half of the console will light. Note: If the safety key was in the console when the power cord was plugged in, a "PO" will appear in the speed display. If this occurs, remove the safety key, wait for five seconds and then reinsert it. MANUAL OPERATION Controlling the Speed When the power is turned on, the console will be in the manual mode and the walking belt will be stationary. The speed of the walking belt is controlled with the SPEED buttons. Each time the SPEED increase button is pressed, the speed will increase by 0.1 mile per hour, beginning at 0.5 miles per hour. Each time the decrease button is pressed, the speed will decrease by 0.1 mile per hour. The SPEED buttons can be held down to change the speed rapidly. The speed range is 0.5 to 10 miles per hour. AWARNING: After the SPEED buttons are pressed, it will take a few seconds for the walking belt to reach the selected speed setting. Adjust the speed gradually until you are familiar with the operation of the treadmill. Press the SPEED increase button until the walking belt begins to move at slow speed. Hold the handrails and step carefully onto the walking belt. Change the speed of the walking belt as desired by pressing the SPEED buttons. To stop the walking belt, hold down the SPEED decrease button. The walking belt can be stopped quickly, if 8 desired, by pressing the STOP button.