Weslo Flex 505 English Manual - Page 5

4. Press a 1 1/2" x 2" Endcap (13) into the top of the Bench Leg (11). Make sure that the Endcap is turned so the holes near the upper end of the Bench Leg are not blocked. Attach the Bench Leg to the Bench Rail (10) with two 7/16" x 2 3/4" Bolts (27), two 7/16" Washers (26) and two 7/16" Nylon Locknuts (7). Be sure that the Bench Leg is turned so that the indicated hole is away from the Bench Rail (10). Center a Foam Pad Tube (45) in the Bench Leg (11). Note: The Foam Pad Tubes are similar to the Weight Tubes (not shown), but the Foam Pad Tubes are slightly larger in diameter, Wet the ends of the Foam Pad Tube and the insides of two Foam Pads (46) with soapy water. Slide the Foam Pads onto the Pad Tube. Attach the Bench (12) to the Bench Rail (10) with four 1/4" x 1/2" Bolts (8) and four 1/4" Washers (9). Do not tighten any of the Bolts until you have threaded all bolts into place. The narrow end of the Bench must be on the end shown. 5. Attach the Bench Rail (10) to the Bottom Upright (2) with two 7/16" x 2 3/4" Bolts (27), 7/16" Washers (26) and 7/16" Nylon Locknuts (7). 4 12 . .. : 8 Narrow End 13 Hole . . .. 27 7. ' 10 2 6 • 11 9 7 ....-.... . • .... . . 45 4 : 46 5 10 , 27 , .,•7 26 2 6. Press two 1 1/2" x 2" Endcaps (13) into the Leg Lever (40). Attach the Leg Lever to the Bench Leg (11) with the Leg Lever Pin (43) and the Hairpin Cotter (44). Wet the tube on the Leg Lever (40) and the insides of the two Leg Lever Pads (42) with soapy water. Slide the Leg Lever Pads onto the Leg Lever. 6 13 43--_____4 4 0 .42 0, , N ,..,- ,40 0 44 Foam Pad Tube 42 7. Attach the Backrest Bracket (55) to the Top Upright (1) with a Weightband Tube (28) and two Large Spring Clips (31). Slide a Weightband Spacer (41) and a Weightband Stopwasher (49) onto each post on the Top Upright (1). 11 13 7 co----- -49 414 i ® 55 H 31 0 K 0: . 28 .m 31 5 0 C V